Top-fix hinges solve exactly that access problem by using a bolt and a quick-release or turn-to-tighten fixing that can be adjusted entirely from above the pan, with no need to get underneath at all. This has made top-fix the standard choice on most new soft-close seats sold in the last several years, and it is usually the easier option to specify when the underside of the pan is difficult to reach or when the original fixing has seized.

A cistern that never quite stops filling is one of the most common callouts a plumber gets, and the fix hinges on correctly identifying which of two components has failed: the fill valve or the flush valve. Get this wrong and you swap a part that was never the problem, then head back out a second time.

Before placing an order, it pays to note three things on site: whether the cistern sits flush to the pan or is wall-mounted above it, the fill valve's body length if there is a tight fit inside the tank, and whether the existing lever operates through the lid or via an external arm. Plumb2U carries fill valves, flush valves and levers suited to both close-coupled and low-level cisterns, stocked at trade prices for plumbers who need to get the right part on the first order rather than the second. Trade supplies despatch from Plumb2U's Epsom base to plumbers across the UK, and Plumb2U remains a straightforward call when the cistern type is not obvious from the pan alone.

Measuring before ordering saves a return trip: the thread diameter of the existing lever body, the distance from the lever mounting to the flush valve connection point, and whether the arm needs to sit above or below the water line all affect which replacement will actually fit. A lever bought to the wrong thread size will not seal against the cistern wall, however well the rest of the job goes.

Cable-actuated systems use a flexible hose supplier cable in place of the rigid spindle, which allows the button to be positioned somewhere other than directly above the flush valve, useful on concealed cisterns and certain close-coupled designs where the lid mechanism does not line up with the valve beneath. The cable itself can stretch, kink or seize inside its outer sheath over time, and a button that has become stiff, or one that no longer springs back after use, usually points to the cable rather than the flush valve itself.

The second check is a knocking or banging sound, sometimes called water hammer, that happens specifically at the moment the fill valve shuts off rather than during the fill itself. This is far more often a mains pressure issue than a valve fault, caused by the sudden stop of a fast-moving column of water hitting the closed valve and sending a shock through the pipework. A fill valve replacement on its own will sometimes quieten this slightly, particularly if swapping to a bottom-entry valve which fills more gently, but it will not fully resolve a genuine water hammer problem, which usually needs an air-filled arrestor fitted at the supply if it persists.