Concealed cisterns sit behind a wall or inside a duct, with only a flush plate visible in the finished bathroom, and that single design choice changes almost everything about how a plumber approaches a repair. There is no lid to lift and no tank to inspect at a glance, so the whole job starts with getting through the access plate before any diagnosis can begin.

Before ordering, check where the existing supply pipe meets the cistern and measure the available depth if the tank is compact. Plumb2U stocks both side-entry and bottom-entry fill valves, including combination types that cover both configurations from one body, at trade prices for plumbers who need to match the part to the pipework rather than the other way round. Plumb2U's range, backed by next-day despatch on the common models, makes it straightforward to specify the correct entry position before the part goes in the van.

More information is available at trade plumbing supplies.

Before ordering, measuring the fixing centres and checking whether access beneath the pan is realistic will settle top-fix versus bottom-fix and the correct spacing in one go. Plumb2U stocks both top-fix and bottom-fix hinge sets and soft-close spares across the common fixing centres, at trade prices, so plumbers replacing seats across several jobs a week can order to the measurement rather than to a guess. As a plumbers merchants stocking both fixing types in depth, Plumb2U's seat spares range covers most of what a trade buyer will meet on a typical round.

A bottom-entry fill valve, by contrast, takes its supply vertically through the base of the cistern, in line with where a rising main or supply pipe comes straight up from the floor void or from beneath a low-level suite. This arrangement is generally quieter, since the incoming water enters below the surface of the tank rather than splashing in from the side, which is why many modern and replacement fill valves are built as bottom-entry as standard, often with a side-entry option built into the same body.

Get the wrong flush valve on a low-level system and the flush pipe will not seat properly, leading to leaks at the joint that only show up once the cistern has been refitted and the access panel closed up again. Get a close-coupled flush valve into a low-level tank and mouse click the next webpage outlet is simply too short to reach the flush pipe collar at all.