A welding table is easy to overlook when planning a workshop, yet a poor one undermines accuracy on every job that touches it. If the surface isn't flat, nothing clamped or squared against it will be either, and small errors compound quickly on anything with multiple joints or angles.

Plasma cutting uses a jet of ionised gas, usually compressed air, forced through a nozzle at high speed and heated by an electric arc to a temperature hot enough to melt through electrically conductive metal. The molten material is then blown clear by the same jet, leaving a narrow, clean cut. Unlike oxy-fuel cutting, plasma works on any conductive metal, including stainless steel and aluminium, not just carbon steel. Hypertherm is the plasma cutting brand we get asked about most, and it's worth understanding the basics before comparing specific units.

Matching duty cycle to actual workload, rather than just chasing the highest amperage figure, is the difference between a machine that keeps up with the job and one that keeps tripping out halfway through it, and it's a question worth raising with a supplier before you buy, such as arc welding machines.

Ambient temperature and airflow around the machine also affect real-world performance. A welder working in a hot, poorly ventilated space, or one that's been boxed in against a wall with no clearance for its cooling fan, will hit thermal cut-out sooner than the same machine used with proper clearance in a cooler environment. Keeping vents clear and giving the unit room to breathe protects both the duty cycle you paid for and the components inside.

A gas lens sits in place of the standard collet body and uses a fine mesh to straighten the shielding gas flow into a smoother, more laminar stream around the arc. This generally allows a longer stick-out from the cup without turbulence pulling in surrounding air, which is particularly useful when working in tighter joints or awkward positions where the torch needs to sit further back from the work.

MIG (metal inert gas) welding feeds a continuous wire electrode through a gun, shielded by a gas supply, which makes it fast and relatively forgiving for general fabrication, sheet steel and repair work. Jasic's MIG range is one of the more popular starting points here, covering entry-level compact units through to higher-output machines as work scales up. TIG (tungsten inert gas) uses a non-consumable tungsten electrode with a separate filler rod, giving a slower but tidier result that's favoured for thinner materials, aluminium and stainless steel where finish quality matters. MMA, or stick welding, strikes an arc from a flux-coated electrode and needs no shielding gas at all, which makes it the most portable option and a common choice for outdoor or on-site work on thicker steel.